Filter
Top Products
3
Installing a New G700 with an S8300
Administer Communication Manager
152 Installation and Upgrades for G700 and S8300
December 2003
Example Node Names Screen
2 Enter the name and IP addresses for the LSPs.
3 Press F3 (ENTER) when complete.
Administer Network Regions
Before assigning an IP network region to a G700, you must define network region on the IP Network
Region form. After a network region is defined, you can assign it to the various network elements
(servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use the system
defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region, defined as
1.
The procedure below uses 1 for the network region number as an example but the procedure applies for
any network region number from 1 to 250.
Define IP network region 1
CAUTION:
Defining IP network regions can be quite complex. For detailed information on the use and
administration of IP network regions, see ‘‘Administration for Network Connectivity for
Avaya Communication Manager, 555-233-504.’’
1 At the SAT prompt, type change ip-network-region 1.
The S8300 displays the IP Network Region screen.
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-10-lsp
192.168.1 _.50_ _______________ ___.___.___.___
node-11-lsp
192.168.1 _.51_ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___