Filter
Top Products
5
Upgrading an Existing G700 with an S8300 — R1.x to R2.0
On-site Preparation for the Upgrade
Installation and Upgrades for G700 and S8300 221
December 2003
The following table maps the release number to the
Reports as: field and specifies whether or not
a pre-upgrade update is required.
Pre-Upgrade Tasks — If the S8300 is the
Primary Controller
Skip to Upgrade the S8300 on page 227, if the S8300 is configured as an LSP.
CAUTION:
If you are upgrading an S8300 primary controller that has LSPs registered to it, the LSPs
must be upgraded before the primary controller. (You can use the SAT command, list
media-gateway, to see if there are LSPs registered to the S8300.)
Perform the following procedures if you are upgrading an S8300 that is configured as a primary
controller.
NOTE:
It is no longer necessary to disable Terminal Translation Initialization (TTI) before an
upgrade or to enable it after an upgrade.
Clear Alarms
1 On the Maintenance Web Interface under Alarms and Notification (Alarms for R2.0), click View
Current Alarms
(Current Alarms for R2.0).
2 If no alarms are listed, skip the next two steps.
3 If alarms are listed, click Clear All.
4 Resolve any remaining major alarms through the Communication Manager SAT.
Check Link Status
1 Open a SAT session.
Software Release Numbers
Release Number
Reported as
Release
Number
Pre-upgrade
update
Required?
From: R011x.01.0.xxx
To: R011x.01.9.xxx
1.1.0 to 1.1.9 No
From: R011x.02.0.xxx
To: R011x.03.0.xxx
1.2.0 to 1.3.0 Yes
From: R011x.03.1.xxx
To: R011x.03.9.xxx
1.3.1 to 1.3.9 No
From: R012x.00.0.xxx
To: R012x.00.9.xxx
2.0.0 to 2.0.9 No