Filter
Top Products
1
Roadmap and Reference
Connection and Login Methods
Installation and Upgrades for G700 and S8300 63
December 2003
you will be given the current list of set commands available. If you type:
P330-1(super)#> set interface help
you will be given a much more restricted list of command possibilities that address the possible
interfaces to be set.
For a complete list of command line interface commands, type help or refer to the "Avaya P330 User’s
Guide" (available at www.avaya.com/support).
Log in to the P330 Stack Processor with a
LAN Connection
1
With a connection to the customer’s LAN (either remotely or on site), telnet to the P330 stack
processor IP address:
Type telnet <xxx.xxx.xxx.xxx>, where <xxx.xxx.xxx.xxx> is the IP address of the P330 stack
master processor on the customer’s LAN.
2 Login at the Welcome to Avaya P330 screen.
Login: xxx from the planning documentation
Password: xxx from the planning documentation
You are now logged-in at the Supervisor level. The prompt appears as
P330-1(super)#.
Log in to the P330 Stack Processor with a
Direct Serial Connection
Use this procedure to access the G700 processors when your laptop is directly connected to the Console
port via a serial cable.
To access the G700 via the Console (serial) port
1 Launch Windows® HyperTerminal or any other terminal emulation program.
NOTE:
For most Windows-based PCs, you access the HyperTerminal program from the Start
menu by selecting
Programs, then Accessories.
2 Choose Call - Connect (for HyperTerminal) or the appropriate call command for your terminal
emulation program.
3 Login at the Welcome to Avaya P330 screen.
Login: xxx from the planning documentation
Password: xxx from the planning documentation
You are now logged-in at the Supervisor level. The prompt appears as
P330-1(super)#.