Filter
Top Products
C
Equipment List
360 Installation and Upgrades for G700 and S8300
December 2003
Provides the ability to remotely troubleshoot the MM 710 T1/E1 Media Module. It is required for
any customer with a maintenance contract and highly recommended for any other customer.
Material Code: 107988867 Apparatus Code: None Required for any customer
with a maintenance contract
and an MM710 T1/E1 Media
Module, highly recommend
for other customers to avoid
expensive technician visits.
MM711 Analog Media Module
The MM711 Analog Media Module supports eight analog interfaces allowing the connectivity of
Loop Start, Ground Start, Analog DID trunks, and 2-wire analog Outgoing CAMA E911 trunks.
As well, the MM711 Analog Media Module allows connectivity of analog, tip/ring devices such
as single line telephones, modems or group 3 fax machines. Each port may be configured as
either a trunk interface or a station interface.
Also included is support for caller ID signaling, ring voltage generation for a variety of
international frequencies and cadences and administrable line termination styles.
Material Code: 170899 Apparatus Code: MM711 Optional
ComCode (for Services Ordering Only): 700221146
MM712 DCP Media Module
The MM712 DCP Media Module allows connectivity of up to 8 two-wire DCP voice terminals.
MM712 will not support 4-Wire DCP telephones.
Signal timing specifications for the MM712 support TDM Bus Timing in receive and transmit
modes. The G700 Media Gateway supplies only +5 VDC and –48 VDC to the MM712 Media
Module. Any other required voltages must be derived on the module.
Loop range secondary protection is provided on the MM712. The MM712 is also self-protecting
from an over current condition on a tip and ring interface.
Material Code: 170898 Apparatus Code: MM712 Optional
ComCode (for Services Ordering Only): 700221153
MM720 BRI Media Module
Table 20: Equipment List: Media Modules Continued
Media Modules
2 of 3