Filter
Top Products
3
Installing a New G700 with an S8300
Administer Communication Manager
Installation and Upgrades for G700 and S8300 155
December 2003
LSP Screen
2 Enter the node name for each LSP supported by the primary controller and submit the form.
The Primary Controller is an S8500 or S8700
(the S8300 Is an LSP)
CAUTION:
This administration applies only to an S8500 or S8700 that serves as the primary
controller for the target G700. Do not administer Communication Manager on the S8300
(LSP). Translations are automatically copied to the LSP from the S8700 primary
controller after a save translations command or a data backup.
If the primary controller is an S8300, skip this section and go to The Primary Controller is an S8300
on
page 151.
NOTE:
Some of the procedures in this section should have been completed previously as part of a
normal S8500 or S8700 installation.
This document covers only the administration of Communication Manager required for the G700 Media
Gateway to communicate with the primary controller over a customer’s network. For the majority of
required administration, see ‘‘Administrator’s Guide to Avaya Communication Manager, 555-233-506,’’
or ‘‘Administration for Network Connectivity for Avaya Communication Manager, 555-233-504.’’
In this section, you will use the SAT interface to:
• Assign Node Names
• Define the IP Network Region
• Add a Media Gateway
change lsp Page 1 of 16
LOCAL SURVIVABLE PROCESSOR
Number NAME IP Address Service Translations
State? Updated
1 node-10-LSP
_ 192.168.1.50 in-service 14:21 5/4/2003
2 ____________ out-of-service
3 ____________ out-of-service
4 ____________ out-of-service
5 ____________ out-of-service
6 ____________ out-of-service
7 ____________ out-of-service
8 ____________ out-of-service
9 ____________ out-of-service
10 ____________ out-of-service
11 ____________ out-of-service
12 ____________ out-of-service
13 ____________ out-of-service
14 ____________ out-of-service
15 ____________ out-of-service
16 ____________ out-of-service