Filter
Top Products
1
Roadmap and Reference
Installation Roadmap and Task Lists
36 Installation and Upgrades for G700 and S8300
December 2003
Configure the S8300 on page 123 - Backup data
- Set server indentities
- Configure Ethernet interfaces
- Configure LSP
- Configure Ethernet adjuncts
- Configure External DNS server
- Set Static network routes, if necessary
- Configure network time server
- Set modem interface
- Update system
- Load Key files, if necessary
Configure the G700 Media Gateway
on
page 137
- Assign IP addresses to the G700 processors
- Set up IP routing for the stack
- Set up default IP route for the G700
- Check IP connections
- Set up controller list for the G700
- Configure X330 Expansion Module, if necessary
Install New Firmware on the G700
on
page 145
- Verify contents of the tftp directory
- Determine which firmware to install
- Install firmware on the P330 stack processor
- Install firmware on the G700 media gateway
processor
- Install firmware on the media modules
- Install firmware on other G700s in the stack or
network, if any
Administer Communication Manager
on page 151
- Reboot the system
- Assign node names, if necessary
- Administer network regions
- Assign LSPs to network regions
- Administer IP interfaces
- Administer the LSP form
- Add media gateway
- Verify changes
- Enable announcements, if necessary
- Save translations
Considerations for IP Phones Supported
by a Local Survivable Processor on
page 164
Set Up SNMP Alarming on the G700
on page 166
Table 1: Install New G700 with an S8300 (Primary or LSP) Continued
Major Tasks Subtasks
2 of 3