Filter
Top Products
1
Roadmap and Reference
Installation Roadmap and Task Lists
38 Installation and Upgrades for G700 and S8300
December 2003
Checklist 2:
Install a New G700 without an S8300
Use the following checklist to install a G700 Media Gateway with the following characteristics:
• The G700 does not have an S8300 and is controlled by an external S8300, S8500, or S8700 Media
Server.
You will use Chapters 2 and 4 with this checklist.
For help with connecting to and logging in to the G700, see Connection Methods
in this chapter.
Table 2: Install a New G700 without an S8300
Major Task Subtasks
Before Going to the Customer Site
on
page 174
- Get planning forms
- Get the G700 serial number
- Set up TFTP server, if necessary
- Download firmware files
Installing Hardware for the G700
Media Gateway and S8300 Media
Server on page 69
- On site checklist
- Unpack and check the order
- Install the G700
- Cable multiple units
- Attach ground conductors
Configure the G700
on page 178 - Assign IP addresses to the G700 processors
- Set up IP routing for the stack
- Set up default IP route for the G700
- Check IP connections
- Set up controller list for the G700
- Configure X330 Expansion Module, if necessary
Prepare to Install Firmware on the
G700 on page 191
- Verify contents of the tftp directory
- Determine which firmware to install
on page 193 - Install firmware on the P330 stack processor
- Install firmware on the G700 media gateway
processor
- Install firmware on the media modules
- Install firmware on other G700s in the stack or
network, if any
1 of 2