Filter
Top Products
3
Installing a New G700 with an S8300
Administer Communication Manager
156 Installation and Upgrades for G700 and S8300
December 2003
NOTE:
For information on installing the CLAN boards on the S8500 or S8700 port networks and
complete information on installing an S8700 Media Server, see the Installation
documentation on the ‘‘Avaya S8300, S8500, and S8700 Media Server Library CD, 555-
233-825.’’
Assign Node Names and IP Addresses for the
C-LANs and LSPs
NOTE:
The CLAN boards must be TN799DP running version 5 or greater firmware. Be sure to
check the firmware version for these boards on the S8700. For information on how to
upgrade the firmware on the S8700, please see the section "Upgrade Firmware in Selected
Port Cabinet Packs" in Upgrading the Avaya Media Server Configuration in the S8700
documentation portion of this documentation CD, ‘‘Avaya S8300, S8500, and S8700
Media Server Library CD, 555-233-325.’’
Assign node names and IP addresses
1 At the SAT prompt, type change node-names ip to open the Node Names screen.
Example Node Names Screen
2 Enter the name and IP address for the C-LANs and LSPs.
3 Press F3 (ENTER) when complete.
Administer Network Regions
Before assigning an IP network region to a G700, you must define network region on the IP Network
Region form. After a network region is defined, you can assign it to the various network elements
(servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use the system
defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 LSP and an S8500 or S8700 as the primary controller, there may be more than
one network region, since there can be up to 250 G700 Media Gateways connected to the S8500 or S8700
with thousands of telephones in the network. In this case, you define a network region for each CLAN
board on the S8500 or S8700 port networks, though they may also have the same network region.
The G700, in this case, may also share the same network region as the CLAN board(s). However, it may
have a different network region because of the geographic distances of the connections between the G700
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-1-clan __
192.168.1 _.124 _______________ ___.___.___.___
node-2
-clan 192.168.1 _.97_ _______________ ___.___.___.___
node-10-lsp
192.168.1 _.50_ _______________ ___.___.___.___
node-11-lsp
192.168.1 _.51_ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___