Filter
Top Products
3
Installing a New G700 with an S8300
Administer Communication Manager
154 Installation and Upgrades for G700 and S8300
December 2003
2 Enter the names of up to six LSPs to be associated with region 1. The LSP names must be the
same as administered on the Node Names form.
3 Submit the form.
4 Repeat for each network region with which you want to associate LSPs.
Administer IP Interfaces
This procedure assigns network region 1, as an example, to the S8300 Media Server.
Assign the network region to the S8300
1 At the SAT prompt, type change ip-interfaces procr.
The S8300 displays the IP Interfaces screen for the media server.
IP Interfaces Screen
2 The field Eth Port should indicate Y (yes). The Node Name should be the IP address of the S8300
Media Server.
Administer the LSP Form
If the primary controller has LSPs, you must enter the LSP node names on the LSP form to enable the
LSPs to get translations updates from the primary controller. Once the LSPs are successfully entered on
the LSP form, their status can be viewed with the
display lsp command.
NOTE:
The LSP node names must be administered on the node-names-ip form before they can be
entered on the LSP form.
Add LSP names to the LSP form
1 At the S8300 SAT prompt, type change lsp to open the LSP form.
change ip-interfaces procr Page 1 of 1
IP INTERFACES
Type: PROCR
Node Name: procr
IP Address: 135.9.41.146
Subnet Mask: 255.255.255.0
Enable Ehternet Port?
Nework Region: 1