Introduction
Video Recorder - User Manual 5
Table 1-1 Specifications (continued)
Input Impedance 51K 5.6K
Input Current 0.9 mA @ 100 Vac 1.1 mA @ 12 Vdc
3.2 mA @ 24 Vdc
Minimum ON Current 0.3 mA 0.3 mA
Maximum OFF Current 0.15 mA 0.2 mA
Base Power Required* 50 mA maximum 50 mA maximum
OFF to ON Response 5 to 30 ms 1 to 8 ms
ON to OFF Response 10 to 50 ms 1 to 8 ms
Logic Inputs
Number 6 (dry contact) per module, up to 6 modules per video recorder
Isolation from ground 2300 Vac/1 min.
Switching Voltage 5 Vdc
Switching Current 5 mA
Digital Outputs
AC Outputs DC Outputs
Number 6 per module, up to 6 modules per video
recorder. Only 1-5 on each module can
be configured as DAT outputs.
6 (current sinking) per module, up to 6
modules per video recorder. Only 1-5
on each module can be configured as
DAT outputs.
Operating Voltage 15 to 264 Vac 10.2 to 26.4 Vdc
Output Type SSR (Triac) NPN open collector
Peak Voltage 264 Vac 40 Vdc
AC Frequency 47 to 63 Hz N/A
Isolation from ground 2300 Vac/1 min. 1100 Vac/1 min.
Isolation between outputs 350 Vac 30 Vac
ON Voltage Drop <1.5 Vac (>0.1A)
<3.0 Vac (<0.1A)
1.5 Vdc maximum
Maximum Load Current 0.5A per point 0.3A per point
Maximum Leakage Current 4 mA (264 Vac, 60 Hz)
1.2 mA (100 Vac, 60 Hz)
0.9 mA (100 Vac, 50 Hz)
0.1 mA @ 40 Vdc
Maximum Inrush Current 10A for 10 ms 1A for 10 ms
Minimum Load 10 mA 0.5 mA
Base Power required* 20 mA/ ON pt. 250 mA
maximum
120 mA maximum
5V
OFF to ON Response 1 ms 1 ms
ON to OFF Response 1 ms +1/2 cycle 1 ms
Fuses (European type 5 x
20mm)
1 per output, 1.0A slow blow 1 per output
1A fast blow
Relay (Alarm) Outputs
Number 6 per module, up to 6 modules per video recorder. Only 1-5 on each module can be
configured as DAT outputs.
Contact Rating 2A, 250 Vac on resistive load
Isolation from ground 2300 Vac/1 min.
Isolation between outputs 2300 Vac/1 min.
Contact Type SPST normally open (NO), individually configurable to normally closed (NC) via
jumper
* Base Power Required is the power required to provided module operation within specifications.