Filter
Top Products
Programming Function Blocks and Features
Video Recorder – User Manual 85
Table 4-3 Labels for Function Blocks
Prompt Range/Selections Definition
DESCR Enter 16 characters maximum. Called a descriptor. Usually appears as
a header or title on some displays and
reports. For alarms, this is the actual
alarm message. If labeling is enabled,
the descriptor can be edited in the
function block’s program menu.
TAG Enter 7 characters maximum. Identifies the point or function on most
displays and reports. Each tag must be
unique. If labeling is enabled, the tag
can be edited in the function block’s
program menu.
UNITS
Default choices:
PSI DEGR
BAR K
MW MV
GPH V
GPM OHM
GPS HZ
GAL MA
LPH %
LPM PH
LPS KG
LITR GRAM
DEGC LB
DEGF
Shows units of measure for analog
values on most displays and reports.
This list of units can be changed under
the ENGINEERING UNITS menu item. If
labeling is enabled, the units can be
edited in the function block’s program
menu.
ON STATE
OFF
UP
START
LOW
RESET
TRUE
LEFT
DECRS
LOAD
COOL
ON
DOWN
STOP
HIGH
RUN
FALSE
RIGHT
INCRS
UNLOAD
HEAT
FILL
EMPTY
IN
OPEN
HOLD
READY
ALARM
AUTO
SP1
NO
PAUSE
DRAIN
FULL
OUT
CLOSED
ACTIVE
ABORT
NORMAL
MANUAL
SP2
YES
Select a label describing the ON(1) state
of the discrete function. These labels
cannot be changed.
OFF STATE See ON STATE for default choices. Select a label to describe the OFF (0)
state of the discrete function. These
labels cannot be changed.