Filter
Top Products
Installation
Video Recorder - User Manual 13
2. Installation
What’s in this section?
The following topics are covered in this section.
Topic Page
Warning 13
Unpacking 14
Panel mounting the video recorder 15
Wiring the video recorder 17
Terminal connections 19
NOTICE
If this instrument is used in a manner not specified by the manufacturer, the protection provided by the
instrument may be impaired.
2.1 Warning
To avoid the risk of electrical shock which could cause personal injury, follow all safety notices in
this documentation.
Protective earth terminal. Provided for connection of the protective earth supply system conductor.
• POWER SUPPLY
Ensure the source voltage matches the supply voltage of the video recorder before power on.
(In the rear of the video recorder, near to the connector of the power supply)
• PROTECTIVE GROUNDING
Make sure to connect the protective grounding to prevent an electric shock before power on.
Do not operate the instrument when protective grounding or fuse might be defective.
To avoid a potential shock hazard, never cut off the internal or external protective grounding
wire or disconnect the wiring of protective grounding terminal.
• FUSE
To prevent a fire, make sure to use the appropriate fuse (current, voltage, type). Before
replacing the fuse, turn off the power and disconnect the power source. Do not use a different
fuse or short-circuit the fuse holder.
• DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable liquids or vapors. Operation of any
electrical instrument in such an environment constitutes a safety hazard.
• NEVER TOUCH THE INTERIOR OF THE INSTRUMENT
Inside this instrument, there are areas of high voltage; therefore, never touch the interior if the
power is connected. This instrument has an internal changeable system; however, internal
inspection and adjustments should be done by qualified personnel only.
• If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
• Do not replace any component (or part) not explicitly specified as replaceable by your supplier.
• INSTALL INDOOR ONLY.