Filter
Top Products
Setpoint Profiler
Video Recorder – User Manual 203
How to hold a profiler
Table 5-14 Profiler Hold Procedure
Step Action Result/Notes
1 Perform steps 1 and 2 from Start procedure
(Table 5-13).
Profile menu is displayed.
2 Press Decrement button to move cursor to
Hold. Press Enter.
The profiler is held at its present value and the
segment’s events are frozen. Elapsed time
continues. Run time stops. Events are held at
their current states.
ATTENTION
A profile can also be put on HOLD by pressing the F2 button, but only if that profile’s HOLD parameter was
configured as SY1 F2. See Section 5.4.
How to reset a profiler
Table 5-15 Profiler Reset Procedure
Step Action Result/Notes
1 Place profiler in Hold. See Profiler Hold procedure inTable 5-14.
1 Perform steps 1 and 2 from Start procedure
(Table 5-13).
Profile menu is displayed.
2 Press Decrement button to move cursor to
Reset. Press Enter.
Profiler is reset to segment #1. All profiler timers
are reset. All events go OFF. Profiler output
goes to starting value of segment #1.
ATTENTION
A profile can also be RESET by pressing the F3 button, but only if that profile’s RESET/RUN parameter was
configured as SY1 F3. See Section 5.4.