Filter
Top Products
3745 Panel Codes
Table 1-5 (Page 26 of 33). Panel Codes. An
following a panel code denotes that the code should 'Blink'.
Panel
Code
Definition
Action: Go to “3745 FRU Group
Table” on page 1-49
or to MAP number
D3E
Moss level 0 error detection; disk errors during
IML/dump; record not found (L/operator intervention
required)
If loading from diskette (function 9
from the control panel) then exchange
the FRU group 45; if loading from
HDD then exchange the FRU group
46
D3F Unused
Go to “MAP 3220: Undefined Panel
Message” on page 2-5
D40
Moss level 0 error detection; disk errors during
IML/dump; CRC/ECC error on ID
Go to
IBM 3745 Service Functions
D41
Moss level 0 error detection; disk errors during
IML/dump; CRC/ECC error on data
D42
Moss level 0 error detection; disk errors during
IML/dump; bad track detected
D43
Moss level 0 error detection; disk errors during
IML/dump; format error detected
D44
Moss level 0 error detection; disk errors during
IML/dump; unable to find ID
Go to
IBM 3745 Service Functions
D45
Moss level 0 error detection; diskette errors during
IML/dump; format error detected
Exchange the FRU group 47
D46 to D4F Unused
Go to “MAP 3220: Undefined Panel
Message” on page 2-5
D50
Moss level 0 error detection; disk errors during
IML/dump; disk change information
If loading from diskette (function 9
from the control panel) then ensure
the diskette is correctly inserted and
that the diskette drive operator handle
is closed. If no problem in this area,
then exchange the FRU group 45
If loading from HDD then exchange
the FRU group 46
D51 to D75 Unused
Go to “MAP 3220: Undefined Panel
Message” on page 2-5
D76
Moss level 0 error detection; disk errors during
IML/dump; PIO MCK (non-recursive)
Exchange the FRU group 7
D77 to DF5 Unused
Go to “MAP 3220: Undefined Panel
Message” on page 2-5
DF6
Moss level 0 error detection; disk errors during
IML/dump; PIO MCK (recursive) - (preemptive request
class.)
Exchange the FRU group 7
DF7 Unused
Go to “MAP 3220: Undefined Panel
Message” on page 2-5
DF8
Moss level 0 error detection; device errors during
IML/dump; dump directory entry not found
If loading from diskette (function 9
from the control panel) then the
problem may be a possible incorrect
diskette in the drive. If OK then try
the backup diskette. If problem still
exists then exchange the FRU group
18
OR
If loading is from the disk then restore
the disk. Refer to
IBM 3745 Service
Functions
If problem still exists then
exchange the FRU group 48. Record
the following action for use if the
problem is not corrected by the FRU
exchange; A MOSS microcode
problem is suspected. Contact your
support structure, refer to “Contacting
Support” on page A-1.
1-40 3745 Models 130 to 17A: MIP