Filter
Top Products
3745 FRU Exchange Procedure
Control Panel Exchange Procedure
Removal Procedure
1. Inform the customer that the 3745 is to be
powered OFF.
2. Press Power Off on the control panel.
3. Open the front door.
4. Switch CB1 OFF. Refer to Figure 4-58.
5. Locate the control panel and the MOSS.
Refer to Figure 4-58.
6. Open the control panel door (one screw must
be removed).
7. Remove the MOSS right cover (three screws
must be removed 1). Refer to Figure 4-59.
8. Refer to Figure 4-58 and to Figure 4-60 on
page 4-47, then remove (from the MOSS
board) the cable going to the control panel
(Y0-D1).
9. Release the cable from its securing points.
Refer to Figure 4-61 on page 4-47 and do the
following:
Figure 4-58. Panel, MOSS, and CB1 Locations
Figure 4-59. MOSS Right Cover
4-46 3745 Models 130 to 17A: MIP