Filter
Top Products
CE leaving procedure
4. IML the MOSS as follows:
Set service to 0 (normal mode).
Set function to 1 (MOSS IML).
5. Do all actions that apply in the following list:
6. Log Off the console by typing OFF on any displayed screen.
7. Set the console in use according to customer requirements.
8. Restore the power mode as it was before your intervention.
9. Do all the actions that apply in the following list:
Exchanged a FRU with a Different PN Upgrade the CDF. Refer to the
IBM 3745 Communication
Controller Service Function
(CDF chapter) to upgrade or
verify the CDF.
Used the MIP for an Installation Go back to the installation procedure in the Installation
Manual.
Exchanged the PCC Card or Battery
with Power OFF
Inform the customer that the TOD-clock and scheduled
power ON services will have to be recreated.
Exchanged the HDD 1. Inform the customer that he will have to refresh the
NCP on this disk if he uses HDD to load the control
program.
2. Update the password.
Run the Wrap Diagnostic on the CA Ensure that the wrap plug is removed
and replaced by the normal cable.
If you Have
What you Should Do
Been working on the channels area in
Concurrent Diagnostic mode
Restore the adapters back to NCP, using the channel
service screen. Refer to “CA Restore Procedure” on
page 4-105.
Been working on the TSS, HPTSS, or
ESS adapter area in concurrent diag-
nostic mode
Remove all wrap plugs installed during this service
call.
Replace all modem and line cables removed during
this service call.
If you have altered CDFs during this service call,
check CDFs and update, if necessary. Refer to the
IBM 3745 Communication Controller Service Function
(CDF chapter).
IML the scanners disconnected from NCP during this
call. This can be done by selecting IMS from Menu
1. When IML is complete, the adapters will automat-
ically be connected to NCP.
Ask the customer to reactivate the lines that were
stopped during the maintenance.
Been working with TRSS in concurrent
diagnostic mode
Connect the TRAs you disconnected during this
service call back the to NCP. Refer to “TRA Recon-
nect Procedure” on page 4-105.
Ask the customer to reactivate the lines stopped
during the maintenance.
If you Have
What you Should Do
Chapter 4. 3745 FRU Exchange 4-103