Filter
Top Products
3745 MAPs
Power MAP 3960: Power OFF not Possible in Network Mode
Symptom Explanation Conditions That Could Cause This Symptom
Power OFF is not possible in
network mode
The power control is not in network mode
The Power Off command is not received from the host
PUC
PCC
Host Cable problem
3745 not able to power OFF in local mode
Attention
Power may be present when nothing is dis-
played on the control panel.
001
To enter this MAP: The NCP must be running
and a network Power Off command must have
been issued.
When the power control is in network mode, a 2 is
displayed at the control panel.
Is the power control in network mode?
Yes No
002
– Set the power control to network mode.
Using Power Control scroll till the
value is 2.
Press Validate.
– Re-initiate the Power OFF command from
the host.
Continue with Step 003.
003
Is the Power On indicator lit?
Yes No
004
– The Power OFF command was suc-
cessful.
Go to “CE Leaving Procedure” on
page 4-102.
005
Set the power control in local mode.
Using Power Control scroll till the value is 3.
Press validate.
Press Power Off.
Does the Power On indicator go OFF?
Yes No
006
(Step 006 continues)
006 (continued)
Continue at “Power MAP 3945: Power OFF
not Possible in Local Mode” on page 2-26.
007
– Set the power control to network mode.
Using Power Control scroll till the value is
2.
Press Validate.
– Power the 3745 On by pressing Power
On/Reset.
– Select the IFT diagnostics routine AT05.
Is the Power On indicator still lit?
Yes No
008
You have an NCP or network problem.
Contact your support structure if additional
assistance is required.
009
– Power the 3745 OFF as follows:
Set the power control to local mode:
– Using Power Control, scroll till the
value is 3.
– Press Validate.
Press Power Off.
– Turn the CB1 OFF.
– Exchange the PCC card (01A-X0B). Refer to
Figure 4-9 on page 4-11.
– Turn the CB1 ON.
– Press Power On Reset.
– Set the power control to network mode.
Using Power Control scroll till the value is
2.
Press Validate.
– Select the IFT diagnostics and run routine
AT05.
(Step 009 continues)
2-28 3745 Models 130 to 17A: MIP