Filter
Top Products
3745 FRU Exchange Procedure
MLA Exchange.
33. From step 9 on page 4-34: Obtain the
service processor maintenance password from
the customer in order to logon at the service
processor console.
34. If the logon is already done, go to Step 36. If
it is not done, proceed with Step 35.
35. To log on:
a. In the MOSS-E View window, click on
Program (in the action bar).
b. Click on Log on MOSS-E.
c. Enter the password.
36. In the MOSS-E View window, locate the serial
number of the machine that contains the MLA
card.
37. Click on the associated icon. The serial
number is displayed on the bottom line of the
MOSS-E View window.
38. In the MOSS-E View window double-click on
Service Processor icon.
39. In the Service Processor Menu window, click
on the Configuration Management option.
40. Double-click on the Manage 3745/3746-9x0
Installation option.
41. In the Controller Installation window select
the machine by clicking on the 3745 serial
number for which your are called and click on
Repair.
42. On the Repairs Action for 3745 window
select the Change 3745 MOSS LAN Adapter
option and click on OK.
43. The Controller Repair Message window is
displayed. Perform the following steps before
clicking on OK.
a. Locate the card (refer to Figure 4-10 on
page 4-12).
b. Disconnect the cable attached to the card.
c. Attention: Use the ESD kit and
procedures.
d. Loosen the two thumbscrews and remove
the card.
e. Install the new card and tighten the two
thumbscrews.
f. Reconnect the cable to the card.
g. Replace the board cover(s).
h. Switch CB1 ON.
i. Close the front door.
j. Power ON the 3745.
Note: This action will also run MOSS
diagnostics and complete a MOSS IML. A
successful completion will result in a code
F0E, F0F, or 000. If any other code is
displayed, an error was detected. See
“3745 Control Panel Codes” on
page 1-15.
44. On the Controller Repair Message window
of the MOSS-E, click on OK.
45. On the Controller Installation window, click
on Save.
46. A new window prompts you to install the
installation diskette in the service processor.
47. Click on OK when it is done, a Controller
Saving Message is displayed.
48. Remove the diskette, and click on OK.
49. The Controller Installation window is again
displayed, click on Cancel.
50. Go to “Action to Take After a Diagnostic Run
or an FRU Exchange” on page 4-99.
Chapter 4. 3745 FRU Exchange 4-37