Filter
Top Products
START
3745 Maintenance Actions
If You Want to: Then Go to:
Run 3745 diagnostics in offline mode (ODG) The “3745 Diagnostic Requirement” on page 1-60.
Run 3745 diagnostics in concurrent maintenance
mode (CDG)
The “3745 Diagnostic Requirement” on page 1-60.
Run the 3745/3746-900 LIC wrap test (WTT) “How to Run the Wrap Test (WTT) for TSS, HPTSS, or
3746-900” on page 3-15.
Find information about using the 3745 control
panel
“3745 Control Panel Use” on page 1-78.
Know the definition of a 3745 control panel code The “3745 Control Panel Codes” on page 1-15.
Install a 3745 The
3745/3746-900 Installation Guide
, SY33-2067
Find information about using the 3745 MOSS
console
The
3745 Service Functions Guide
, SY33-2069.
Find information about connected consoles The
3745 Console Setup Guide
, SA33-0158.
Find the level of a FRU installed. The
3745 Service Functions Guide
, SY33-2069.
Check voltages on 3745 The 3745 YZ pages
Change parameters for the 3745 LIC type 5 or 6. Appendix B, “PKD (Portable Keypad Display) Maintenance
Aids for LIC 5 and 6” on page A-5.
Apply a Microcode Fix on the 3745-17A "Handling the Microcode Change Level" in the chapter
"Maintaining the Code Loaded on the Service Processor" in
the corresponding
Service Processor Installation and
Maintenance
manual.
Find information about using the service
processor console
The
3745 Models A, Basic Operations Guide
, SA33-0177.
Test the 3745-17A RSF link “MAP 4510: 3745 Model 17A Manual Call” on page 2-33.
Find information about customer console on
3745-17A
The
3745 Console Setup Guide
, SA33-0158.
Perform Engineering Data Transfer The “Engineering Data Transfer” on page 1-58.
Run diagnostics on the service processor "How to Run the Service Processor Diagnostics" in the cor-
responding
Service Processor Installation and Maintenance
manual.
Run diagnostics on the network node processor The "Network Node Processor Problem Determination" in
the corresponding
Network Node Processor Installation and
Maintenance
manual.
Apply a microcode change on a service processor "Handling the Microcode Change Level" in the chapter
"Maintaining the Code Loaded on the Service Processor" in
the corresponding
Service Processor Installation and
Maintenance
manual.
Find the modem setting for RSF The
Service Processor Installation and Maintenance
manual. Use the "Installing and Connecting the RSF
Modem to the Service Processor" procedure according to
your modem type.
Run diagnostics on the 3746-900 or attached fea-
tures
The
IBM 3746 Nways Multiprotocol Controller Model 900
Service Guide
, SY33-2116.
Find miscellaneous information “Miscellaneous Information” on page 1-13.
1-6 3745 Models 130 to 17A: MIP