Filter
Top Products
3745 MAPs
MAP 3230: Console Link Procedure
The display code that sent you to this procedure
defines the connector or cable referred to in this
procedure.
1A0 or 1A1 local
1A3 or 1A4 remote
1A6 or 1A7 RSF.
001
– A console wrap plug should be installed at the
3745 console connector (see Figure 2-1), or at
the far end of the cable which should be discon-
nected from the relevant console/modem. See
Table 2-1 for the wrapplug part number to be
used.
Was a console wrap plug installed?
Yes No
002
Install the console wrap plug and go to Step
7 of “How to Run the Console Link Test for
3745 Models 130, 150, 160, and 170” on
page 3-6.
003
Was the console wrap plug installed on the
cable?
Yes No
004
The console wrap plug could be faulty.
Change it and go to Step 7 on page 3-6, or
exchange the FRU group 26 on page 1-51
(see page 1-49).
005
– Install a console wrap plug at the 3745 console
connector (see Figure 2-1) and refer to Step 7
on page 3-6 to repeat the test.
Is the code displayed the same as the one with
which you entered this procedure?
Yes No
006
If 1A1, 1A4, or 1A7 is displayed, the cable
from the 3745 is faulty.
– Repair or exchange the cable.
– Verify the repair by re-running the console
link test with the console wrap plug
installed on the cable.
(Step 006 continues)
006 (continued)
– or –
If any other code is displayed, go to “3745
Control Panel Codes” on page 1-15 and
follow the instructions.
007
The console wrap plug could be faulty.
Change the console wrap plug and go to step 7
on page 3-6, or exchange the FRU group 26 on
page 1-51. Go to page 1-49.
R
E
M
O
T
E
R
S
F
L
O
C
A
L
J1 J2 J3
Location: 01R
Figure 2-1. Console Outputs
Table 2-1. Wrap plug PN
PN Console Type
6398697 31XX
2667737 3727
26f0320 Personal computer or
PS/2*
2-6 3745 Models 130 to 17A: MIP