Filter
Top Products
3745/3746-900/Service Processor MAPs
002
The service processor icon is white.
Check if the yellow LED of the service processor (indicating disk access) is active.
If the yellow LED is sometimes ON and sometimes OFF, wait a few more minutes. If the symptom
persists, contact your support center for assistance.
If the yellow LED is always OFF, contact your support center for assistance.
003
The 3745 icon is white.
Check the displayed 3745 control panel code or the 3745 status on the service processor:
– On the MOSS-E View window, double-click on the 3745 icon.
– Click on Program (in the action bar).
– Click on Status option.
– The 3745 Controller Status window indicates the CCU status and the associated control code.
Note the control code displayed. Then go to “3745 Control Panel Codes” on page 1-15 and follow the
procedure.
Table 2-3. Icons Color Selection Table
Machine Icon Color Go to
Service
Processor
White Step 002 on page 2-38.
3745 White Step 003 on page 2-38.
Grey Step 004 on page 2-39.
Pink Step 005 on page 2-39.
3746 Yellow Step 006 on page 2-39.
White Step 007 on page 2-39.
Grey The 3746-900 is not connected to the service processor.
Go to “MAP 5600: LAN Problem on the LAN Attached
to the Service Processor” on page 2-42.
Pink Refer to the
IBM 3746 Nways Multiprotocol Controller Model
900 Service Guide
, SY33-2116.
Red Step 008 on page 2-39.
NNP-X White The control point is starting and the configuration is acti-
vating This is a normal state. However if this state stay a
too long time suspect a problem. Check if you have alarms
at the service processor
Grey There is no connection betweeen the service processor
and the network node processor.
Or
The link is not ready between the 3746-9xx and the
control point of the network node processor.
Refer to the
IBM 3746 Nways Multiprotocol Controller Model
900 Service Guide
, SY33-2116.
Pink The control point is waiting for operator start, or no NDF
(Node Definition File). Refer to the
IBM 3746 Nways Multi-
protocol Controller Model 900 Service Guide
, SY33-2116.
Blue The connection between the service processor and the
network node processor is OK. The network node
processor is in standby mode. The control point must be
started. Refer to the
IBM 3746 Nways Multiprotocol Con-
troller Model 900 Service Guide
, SY33-2116.
2-38 3745 Models 130 to 17A: MIP