Filter
Top Products
AX2500/2850 Motor Controller User’s Manual 163
Loading, Changing Controller Parameters
Controls Settings
The screen shown in Figure 94 is used to view and change the controller’s main control
modes. Below is the list of the parameters accessible from this screen
1- Controller Input:
This pull down menu allows you to select the RS232, R/C or Analog mode of operation. If
the RS232 mode is selected, a check box will appear, allowing you to enable or disable the
RS232 Watchdog. For more information on these modes, see
• “R/C Operation” on page 69
• “Serial (RS-232) Controls and Operation” on page 87
• “RS-232 Watchdog” on page 98
• “Analog Control and Operation” on page 107
2- Motor Control Mode
This pull down menu is used to choose whether the controller will operate in Separate or
Mixed mode. For more information on these modes, see “Selecting the Motor Control
Modes” on page 36.
3- Input Command Adjustment
These pull down menus will let you select one of five conversion curves on each of the
input command values. See “Command Control Curves” on page 42.
4- Emergency Stop or Invert Switch Select
FIGURE 94. Control modes setting screen
1
2
3
4
5