Filter
Top Products
5.4 Network Dedicated Instruction
5.4.32 UINI instruction
5-245
Z_UINI
5
MODULE DEDICATED
INSTRUCTION
Z_UINI
(2) CC-link IE Controller Network
The UINI instruction can be executed only once. The UINI instruction cannot be
executed again after determination of station number. (It caused an error
completion.)
However, in the case of the UINI instruction with the error completion, execute the
UINI instruction again after taking corrective action.
[5]
Operation setting
Communication data code setting
0: Binary code
1: ASCII code
TCP existence confirmation setting
0: Use Ping
1: Use KeepAlive
Transmission frame setting
0: Ethernet frame
1: IEEE802.3 frame
Setting for enabling/disabling write during RUN
0: Disable
1: Enable
Initial timing setting
0: Do not wait for OPEN (communication impossible during STOP
status)
1: Always wait for OPEN (communication possible during STOP status)
0 or 1 User
[6]
to
[9]
– Specify 0.
0User
*1 : The Ethernet module enables data exchange to restart by clearing the address information retained in the
module and by performing re-initial processing.
(The Initial normal completion signal (X19) is on.)
Device Item Setting data Setting range Setting side
[0]
– Specify 0.
0User
[1]
Completion status
The instruction completion status is stored.
0 : Normal completion
Other than 0 : Error completion (error code)
–
System
[2]
Modification specification
Specify the change target
0001H: With station number setting
0001H User
[3]
Host station No. Specify the station number of the host station.
1 to 120 User
[4]
to
[9]
– Specify 0.
0User
Device Item Setting data Setting range Setting side
s
b9 b8 b7 b 6 b5 b4 b2 b1 b0b15
00 0012345
to
b3
s
s
s
s
s
s
s
s