Filter
Top Products
Enhancing Video for Security
104
Authorized Configuration
Event Recording can be configured by the Multi SA in your organization, or by other operators
who have the right to run a
Maintenance Session.
Caution: Using high values for Continuous Recording can shorten a unit’s video archive to
the point of making it unusable. See Using Higher Values When Recording Video, p. 127.
Automatic DSP Performance Maximization
A Multi SA can optimize
Event Recording settings. See Automatic Maximization of DSP
Performance, p.
72.
Multi-Media LT
On Multi-Media LT units, the maximum resolution for NTSC is 640×240; for PAL, 704×288; this is
lower than on Multi-Media DSP units.
Live Video
The settings for Continuous Recording and
Event Recording are independent of those for live
video.
Setting Lower Values for Continuous Recording
The values for Continuous Recording need to be lower (or equal) to the values of Event
Recording . If higher values cannot be set for Event Recording, check if high values are used for
Continuous Recording.
Event Recording on Demand, Using the Boost Button
Once Event Recording is set, View software operators have the option of clicking the Boost
button, while monitoring Live video. See figure
7–2. For the location of the button, see the Rapid
Eye View Software Operator Guide, K14391.
Fig. 7–2. Boost Button.
Event Recording on demand during a Site Tour
In View software, the button for
Event Recording is unavailable while a tour is running. To enable
the button, pause the tour first.