Filter
Top Products
System Administrator’s Guide
Document K14392V1 Rev A 39
07/07
Adjusting a Unit’s IP Settings for NAT
Fig. 3–9. NAT Configuration: Changing the IP Address of a Multi-Media Unit.
1. Ask the network administrator of the remote LAN for the unit’s:
• IP Address
• Subnet Mask
• Gateway. The Gateway on the unit matches the router's Inside IP address; for
example, in figure
3–9, it is set to 192.168.101.1.
2. Enter the values obtained in step 1 using either:
• LocalView software, onsite. Click the Setup tab and then click the System tab.
Use the buttons in the Network Settings box.
- or -
• A PC that runs View and that can connect to the Multi-Media units. Run a
Maintenance Session to the unit. The values are entered on the System tab. See
figure
3–9. This locks out View operators from further use of the unit until the
router and Multi db are updated. See
Setting a Router’s Mappings and Updating
a Unit's Connection. Operators using LocalView are not locked out.