Filter
Top Products
System Administrator’s Guide
Document K14392V1 Rev A 91
07/07
• To pan or tilt, move the mouse through the PTZ camera’s window until the pointer changes to a
numbered arrow. Click. Figure
6–5 shows the Zonal Mode for panning left. For continuous
panning or tilting, click the arrow furthest from the center.
• To stop continuous panning or tilting, move the mouse through the PTZ camera’s window until
the pointer changes to an octagon. Click.
• To zoom, use the wheel on the mouse. If the mouse does not have a wheel, see
Using the
Dartboard Control,
above
Programming a PTZ Dome Camera
Fig. 6–6. PTZ Dome Camera without Auto-focus (1) or with, Between the Dots (2).
PTZ preset
Presets are set during a Maintenance Session. A PTZ camera can be set to return to the first
preset when use of the camera ceases, when a Live session ends.
Auto-focus
View supports an auto-focus control when two dots appear in the “– Focus +” arc of the PTZ
controller. Click between the dots to toggle auto-focus ON/OFF. See figure
6–6.
Auto-iris
View supports an auto-iris control when two dots appear in the “– Iris +” arc of the PTZ controller.
Click between the dots to toggle auto-iris ON/OFF.
To Configure a Preset on a PTZ Camera
1. Continue or start a Maintenance Session.
2. Click the Video tab.
3. Click PTZ.
4. Select a camera whose PTZ preset you need to set.