Filter
Top Products
The Administration of a Rapid Eye System
20
About Using LocalView Onsite
Interface for operating one Rapid Eye unit
Configuration made using LocalView applies only to the unit on which it is running. To find out
how to use LocalView, the interface offers a context-sensitive Help system.
Network connection
If a unit is inserted in a common network, LocalView may be needed by installers to enter the
unit’s IP address. To do so, a Quick Install wizard is available when using LocalView. See the
Multi-Media DSP Unit: Quick Install broadsheet, K14355.
Watching your back
If Multi-Media DSP units are only operated remotely, from PCs, you have the option of preventing
the unauthorized use of LocalView by locking the interface, using passwords for LocalView.
Using a PC: Installing Rapid Eye Software
For Unit Operators: View Software Only
Personnel who operate Multi-Media DSP units—to monitor video, respond to alarms, make video
clips—only need View software on their PCs. Use the View CD-ROM to install View software only.
Figure 1–1. To Install View Software, Run the Multi-Media View CD-ROM.
For the Multi SA Only: Admin and View Software
The system administrator of your Rapid Eye system (Multi SA) needs Admin software and View
software. Use the Admin CD-ROM that came with your unit to install both. If security is important
to your organization, Honeywell recommends that the Admin CD-ROM be used only on the PC of
your organization’s Multi SA.
Fig. 1–2. To Install Admin Software, Run the Multi-Media Admin CD-ROM.