Filter
Top Products
System Administrator’s Guide
Document K14392V1 Rev A 159
07/07
1. While adding or updating an account, click a box next to a right. See figure
9–3. Adding
a checkmark adds the right to the account; remove the checkmark to remove the right.
2. To limit camera access, see
To Limit Use of Cameras: Camera Partitioning on p. 183.
3. After modifying rights, users of Admin need to click Save and Close. Users of LocalView
do not. If Central Management is enabled and the operator account will be used to
operate the unit using View software and LocalView, then use View software to update
security on the unit(s) to which the account will grant access. See
Updating Security on
a Multi-Media Unit, p.
131.
To Base Rights On Those of Another User
This feature is available in Admin only; not in LocalView.
1. Using Admin, click the User tab.
2. While updating or adding the account, click Rights and site access are based on.
3. Choose a user account from the list.
4. Click Save and Close.
User Rights and Security
In organizations with high security requirements
Your Multi SA can use Admin to provide operator accounts that:
1. limit the sites that a user can access. By default, access to all sites is granted. See Right
to Access a Site on p. 182. You can set accounts to access only some sites.
2. limit the amount of time for use of a site. See
Right to Access a Site, on p. 182.
LocalView
When using LocalView, there is no time limit to operating a unit.
To Deny Access
Denying access to sites is a security measure that is used against an operator who must be
stopped from using Multi-Media units as soon as possible. The account data is preserved. For less
severe cases, removing an account may be sufficient; see Removing a User's Account, p. 160.
Denying access to all Multi-Media units: Admin
1. Using Admin, click the Users tab.
2. Double-click the name of the account in the User Name column.
3. Click the box next to Deny this account access to sites [...] so that it shows a checkmark.
4. Click Save and Close.
5. Update security at each site listed in the “User can access selected sites” list. The
procedure to update security is in section
Updating Security on a Multi-Media Unit, on
p. 131.