Filter
Top Products
Document K14392V1 Rev A 19
07/07
1
The Administration of a Rapid Eye System
Start Here
Means of Configuring a Rapid Eye Unit
You have the option of configuring a Multi-Media DSP unit for CCTV use:
• Without using a personal computer (PC). Using LocalView, an interface that runs on the
Multi-Media DSP unit, to configure and operate a unit.
• Using a PC. Run Honeywell Rapid Eye Admin software for the administration of the Rapid Eye
system, and Rapid Eye View software, to operate Rapid Eye units.
• Using either.
Designated personnel: a Multi SA from your organization
To carry out the setup and supervision of Honeywell Rapid Eye™ Multi-Media DSP units, your
organization can designate a System Administrator (Multi SA) for your Rapid Eye CCTV system.
About Using a PC to Operate Rapid Eye Units
Using one Rapid Eye unit, or many at once
Admin software is used to manage a central database (Multi db) of Rapid Eye Multi-Media DSP
units. Older Rapid Eye units (Multi-Media and Multi models) are supported.
View software is used to further configure each of the Multi-Media DSP units for: video, audio, POS
devices and so on. View software can connect to many Rapid Eye units at once, for configuration
and for video, live and recorded, alarm sessions and so on.
The information in this guide (publication number K14392) deals almost exclusively with the use of
a PC to configure Rapid Eye units. For PC requirements, see the Please Read this First!, K14393.