Filter
Top Products
System Administrator’s Guide
Document K14392V1 Rev A 59
07/07
System Clock: Manual Setting
A Multi SA can synchronize the clock of a Rapid Eye Multi-Media unit using a PC’s clock as
reference. This is more useful for units connected only by dial-up, but can also be used for units
on a LAN.
Tip
Check/set the clock on an operator's PC, before setting a unit's clock manually.
Adjusting the Clock on a PC Running Rapid Eye Software
To adjust a PC’s time, date and time zone, click Start followed by Settings, Control Panel and
Date/Time. Check the accuracy of the time and the time zone on the PC and adjust it as needed.
Using a PC’s Clock to Set a Unit’s Clock Manually
1. Using View software, select a Multi-Media unit whose clock needs to be set.
2. Start a
Maintenance Session.
3. Click the Time tab. If Manual is not selected, click it. The Time tab appears as in figure
4–4.
4. Click Set Multi-Media Unit’s Clock.
Fig. 4–4. Setting a Multi-Media Unit’s Clock Manually.
Synchronizing time over dial-up
Due to the nature of dial-up connections, the Multi-Media unit’s time may still be off by a few
seconds after synchronizing time.