Filter
Top Products
System Administrator’s Guide
Document K14392V1 Rev A 245
07/07
To Refresh a Local Database while Running View
1. Run View. At the Logon, check if there is a checkmark in the checkbox next to The
Central database is accessible from this PC.
• If so, proceed with the logon.
• If not, check with your Multi SA if the PC used to run View can connect to the PC
or server holding the Multi Central database. In the affirmative, check the
checkbox next to The Central database is accessible from this PC.
2. While View is running, operators can either:
• Click on the View toolbar.
- or -
• Click the Refresh command on the View menu.
If procedure
To Refresh a Local Database while Running View fails, see your Multi SA.
Deleting a Database
You can delete a Central database at any point. Note that after deleting a Central database, users
can still connect to sites, using their local database. Attempting to refresh the local db causes an
error after the Central db is deleted.
Protecting the Multi db
On some installations, the Multi central database (Multi db) may need to be protected from copy
and deletion. See Multi Database Security on p. 165.
“Cannot Open Db”
Can be the result of:
• Deleting a Multi central database (Multi db)
• Unavailability of a network connection to the Multi db.
Tip
Check the network’s status. When using Admin, this error has the side effect of creating a
new, central database that has the same name as the regular database.