Filter
Top Products
125
CHAPTER 9 PROGRAMMING
9
9.2 Procedure for Programming
9.2 Procedure for Programming
Create a program to execute D/A conversion, according to the following procedure.
9.3 Program Example
(1) System configuration
Start
End
Parameter setting
( )
Error reset program
Auxiliary program*
1
*1 A program that is added according to the
control target (Create a program if needed.)
Page 125, Section 9.3
D/A converter module (NZ2GF2B-60DA4)
Extension output module (NZ2EX2B1-16T)
RY22: Warning output signal (assignment)
RY20: Input signal error detection signal
(assignment)
Remote output signal
assigned by the external
signal assignment function
*1
Master station
(Station No.0)
00 to 1F 20 to 2F
Analog output
(CH1, CH2)
Remote device station
(Station No.1)
*1 Programming is not necessary to output a remote output signal from
the D/A converter module if the signal is assigned by the external
signal assignment function.
Power supply module (Q62P)
CPU module (Q10UDHCPU)
Master/local module (QJ71GF11-T2)
Input module (QX10)