69
CHAPTER 7 VARIOUS SETTINGS
7
7.2 Changing the Parameter
7.2.1 Changing the network configuration
7.2 Changing the Parameter
This section describes the procedures to change the parameter.
The precautions to take when changing the parameter are same as the following.
• Precautions ( Page 64, Section 7.1 (1)
7.2.1 Changing the network configuration
When changing the network configuration diverting the created project, set the parameter in the following procedure.
1. Power off the module.
2. Connect the modules again according to the desired network configuration.
3. Power on the module.
4. Display the "CC IE Field Configuration" window.
• When the master/local module is the QJ71GF11-T2
Project window [Parameter] [Network Parameter]
[Ethernet/CC IE/MELSECNET] button
• When the master/local module is the LJ71GF11-T2
Project window [Parameter] [Network Parameter] [Ethernet/CC IE Field]
button
5. Drag and drop a module to set the slave station. Input a numerical value to set the station number
of the station. Change the value as necessary.