63
CHAPTER 7 VARIOUS SETTINGS
7
7.1 Parameter Setting
CHAPTER 7 VARIOUS SETTINGS
This chapter describes the setting procedures of the D/A converter module.
7.1 Parameter Setting
Set the parameter of this module with the network parameter written to the CPU module of the master station. For the
setting procedure of the master station, refer to the following.
User's manual for the master/local module used
Remark
● Check "Set the network configuration settings in CC IE Field configuration window" on the "MELSECNET/CC IE/Ethernet
Module Configuration" window in advance.
● To select an extension module in the "CC IE Field Configuration" window, select the following models from the "Module
List" window.
● When points less than the ones of the D/A converter module and extension module are set for the remote I/O signal and
remote register, no error occurs. The cyclic transmission is performed for the data of the points set from the start.
Extension module type Name
Input module NZ2EX-16(DI)
Output module NZ2EX-16(DO)