Filter
Top Products
17
CHAPTER 1 D/A CONVERTER MODULE
1
1.2 Features
(7) Error detection and monitoring available
When a digital value exceeds the range set in advance, an alert is detected. Thus, an error of digital value can be
monitored and outputs of a digital value can be limited.
(8) Output available without influence from the sequence scan or link scan
An error status or alert status can be output from the extension output module by using the external signal
assignment function when an error or alert occurs.
The sequence scan or link scan does not influence this output.
(9) CC-Link IE Field Network synchronous communication function available
With this function, the D/A converter module can perform D/A conversion synchronized with the operation cycle
of a simple motion module.
This enables the D/A converter module to operate at the same timing of other slave stations on the same
network.
D/A converter module
Extension output module
An error has
occurred.
An error signal occurred in the D/A
converter module can be output to
the extension output module directly.
Error lamp
(external device)
Programming is not necessary to
turn on an error lamp when an error
occurs.