Filter
Top Products
I
-
I
-
Using Spectrum Analyzer Features
Saving and Recalling Data from Analyzer Memory
To
Save
a
Limit-Line
Table
or
Amplitude
Correction
Factors
The procedure for saving limit-line tables or amplitude correction factors
is similar to saving trace data. State and trace data is not recalled with
limit-line tables or amplitude-correction factors.
1. Enter a screen title, if desired, by using
(j’,
Change Title . The
screen title is displayed when CATALOG REGISTER is used to catalog the
trace registers. The screen title is not recalled, however, with the limit-line
tables or amplitude correction factors.
2. When saving limit-line tables, set up the limit-line table to be stored (see
“Using the Limit-Line Functions” in this chapter). When saving amplitude
correction factors, enter the data using the remote programming AMPCOR
command or use the amplitude-correction function softkeys. See “Using
Amplitude Correction Functions” in this chapter for more information
about entering amplitude correction factors via the front-panel.
3. Press
m.
If CARD is underlined, press INTERNAL CARD to select
INTERNAL.
4. Press Trace
+
Intrril
This accesses a menu with LIMIT LINES and
AMP CDR.
5.
Press LIMIT LINES to save limit-line tables. Press AMP COR to save
amplitude-correction factors. REGISTER # and MAX REG # = are displayed
on the cable TV analyzer screen. The number after MAX REG
#
= indicates
the maximum register number that can be entered for storage in cable TV
analyzer memory.
6. Use the numeric keypad to enter a number from 0 to the maximum
register number and then press
(ENTER).
3-12