Filter
Top Products
I
-
I
-
Power
Menu
POWER ON
IP LAST
Spectrum Analyzer Mode Key Descriptions
Spectrum Analyzer Mode Functions
accesses functions which make transmitter power
measurements. The measurements are designed for analog
radio or continuous carrier digital radio signals.
If another front-panel key is pressed, exiting the power
menus, press the
[w)
key twice to return to the last
power menu that was being used.
Front-Panel Key Access
(a)
determines the state of the analyzer when the analyzer is
powered on. If the POWER ON function is set to IP, the
state of the analyzer is the same as it is after
(PRESET)
is
pressed, when the analyzer is powered on. If the POWER
ON function is set to LAST, then the state that the analyzer
was left in when it was powered off is recalled.
The setting (IP or LAST) of the POWER ON function is not
changed by pressing (PRESET). Use the POWER ON
IP
LAST
softkey function to change the setting of the analyzer state
which is recalled at power on. Limit lines are not recalled
when the analyzer is powered up.
NOTE
If you have a downloadable program or “personality” installed in analyzer memory, the following
changes apply to the operation of the POWER ON function: When using a downloadable program
or personality, the last state of the personality is not recalled. We recommend that if you are
using a downloadable program or personality, you set POWER
OM
IP LAST to
II?
If
POWER ON IP LAST is set to LAST, you must press
C-1
whenever you power on the
analyzer.
Front-Panel Key Access
(CONFIG)
6-111