Filter
Top Products
I
-
I
-
Spectrum Analyzer Mode Key Descriptions
Spectrum Analyzer Mode Functions
Power-sweep measurements are particularly useful in
making gain compression measurements or output power
versus frequency measurements.
Front-Panel Key Access
[AUXCTRL)
accesses softkey menus that allow you to recall data
from the memory card or analyzer memory. When
INTERNAL is selected, states, traces, limit-line tables,
amplitude-correction factors can be recalled from analyzer
memory. When CARD is selected, states, traces, limit-line
tables, and amplitude-correction factors, display images, and
downloadable programs can be recalled from the memory
card.
In addition, pressing
(RECALL]
accesses the cataloging
functions used to catalog the saved data that is in analyzer
memory or on the memory card. It also accesses the DLP
editor utility.
RECALL
AMP
COR
recalls an amplitude-correction factors table from the
current mass-storage device ( analyzer memory or memory
card). To verify the current mass storage device, press
RECALL AMP
COR
. If MAX REG
#
appears on the analyzer
display, the current mass storage device is analyzer
memory. If PREFIX= is displayed, the memory card is
the mass storage device. Press
ISAVE_)
or
(-1,
then
INTERNAL CARD to change the current mass storage device.
To recall an amplitude-correction factors table, enter the
register number that the table was previously saved under,
then press
[ENTERI).
When recalling an amplitude-correction
factors table from the memory card, it may be necessary
to change the current prefix to the prefix with which the
table was stored. Press Change Prefix to change the
current prefix. When saved in analyzer memory, the register
number is restricted to the range between 0 and the number
x indicated by MAX
REG#
= x. The screen title is not recalled
with the amplitude-correction factors table.
Front-Panel Key Access
ICAL)
6-120