Filter
Top Products
I
-
I
-
Spectrum Analyzer Mode Key Descriptions
Spectrum Analyzer Mode Functions
PLT
PIENU
ON OFF
PLTS/PG
124
PLT->LJT
ON OFF
POINT
allows the softkey labels to be plotted along with the
analyzer display. This function operates when the
IcoPv]
key is used in a plot configuration. The PLT MENU ON OFF
function is set to OFF when DEFAULT
COMFIG
is pressed.
Front-Panel Key Access
(CONFIG)
allows you to plot a full-page, half-page, or quarter-page
output. Selecting two plots per page requires a plotter that
has the rotate command (RO). The plotter will be set to a
full-page output when DEFAULT
CONFIG
is pressed.
Front-Panel Key Access
[jj
allows you to plot a full-page, half-page, or quarter-page
output to an HP LaserJet printer. This softkey can be
accessed by pressing
[W),
then Plot
Config
Front-Panel Key Access
(CONFIG_)
specifies a limit value for one coordinate point, so that a
POINT segment specifies a limit value for a single frequency
or time. For an upper limit line, a POINT segment is
indicated by a line drawn vertically from the coordinate
point to a point off the top of screen. For a lower limit line,
a POINT segment is indicated by a line drawn vertically from
the coordinate point to a point off the bottom of screen. The
POINT segment type is generally used as the last segment
in the limit-line table. However, if the last segment in the
table is not of the POINT segment type, an implicit point is
automatically added at the right-hand side of the screen.
If a visible POINT segment at the right-hand edge of the
display is not desired, add an explicit last-point segment to
the limit-line table that is higher in frequency than the stop
frequency.
Front-Panel Key Access
c-1
6-110