Filter
Top Products
I
-
I
-
Using Spectrum Analyzer Features
External Keyboard
To Enter Programming
Commands
Refer to the
HP 8590 E-Series and L-Series
Spectrum
Analyzers and
HP 8591 C Cable TV Analyzer Programmer’s Guide
for more information.
1. Press
(F8)
on the external keyboard to enter the mode for executing
remote commands.
2. Type in a programming command (for example, type IP).
3. Press
@EiEK]
on the external keyboard to execute the command.
NOTE
Unlike entering a remote programming command using an external controller, entering the remote
programming commands with the external keyboard does not require including the cable TV analyzer
address. It is also not necessary to terminate the programming line with a semicolon. However,
semicolons are necessary for separating the programming commands. For example, a program line is
entered via the external controller as: OUTPUT 718;
“CF
300MHZ;
SP
1MHZ;
‘I.
The same
program line is entered using the external keyboard as: CF
300MHZ
; SP
1MHZ
;
CENTER)
After
IF8_1
is pressed, the cable TV analyzer remains in command mode. To
return to the title entry mode, press
LESC]
(on the external keyboard).
To Enter a Prefix
Refer to the
HP 8590 E-Serks and L-Series Spectrum Analyzers and
HP 8591 C Cable TV Analyzer Programmer’s Guide
for more information
1. Press
(F7)
on the external keyboard to enter the mode for entering a
prefix.
2. Type in the prefix.
3. Press
(ENTER)
on the external keyboard.
3-69