Filter
Top Products
I
-
I
-
Spectrum Analyzer Mode Key Descriptions
Spectrum Analyzer Mode Functions
EDGE POL
POS NEG
determines whether the gate triggers on the positive-going
or negative-going edge of the signal at the GATE TRIGGER
INPUT connector (on the rear panel of the analyzer).
If the gate utility is used and a pulse repetition interval
has been entered, gate trigger position markers will be
shown in the time domain window. A
“0”
indicates positive
triggering. A
“4”
indicates negative triggering.
Front-Panel Key Access
@iiCE’)
Edit
Amp
Car
allows you to edit the current amplitude-correction factors
table by accessing the SELECT POINT , SELECT
FREQ
,
SELECT
AMPLITUD
, DELETE POINT , Edit Done , and
PURGE AMP COA softkeys.
Front-Panel Key Access
a
EDIT
CAT ITEM
Refer to the
HP 8590 E-Series and L-Series Spectrum
Analgers
and HP 8591 C Cable TV Analyzer Programmer’s
Guide for more information.
starts the DLP editor function and loads the highlighted item
from the catalog of analyzer user memory to be displayed
and edited. It copies the item into the analyzer DLP editor
memory which is a 2500 byte memory buffer. If an item
is edited, the new edited version will not be overwritten
in the analyzer user memory until it is processed by the
SAVE
EDIT
softkey.
Front-Panel Key Access
(jZZi7)
or
ISAVE_]
6-58