Filter
Top Products
I
-
I
-
Using Spectrum Analyzer Features
learn How to Enter Amplitude Correction Factors
Editing or Viewing the Pressing
ICAL),
More 1 of 4 , More 2 of 4, More 3 of 4, Amp Cor
Amplitude-Correction Tables
accesses the softkey menus for creating an amplitude-correction table.
Amplitude-Correction
Functions
This section describes the amplitude-correction functions in the order they
are usually used.
Selecting the
Amplitude-Correction Point
NOTE
(Fi%ZFi]
turns amplitude-correction factors off (if it is
on),
but does not clear an existing
amplitude-correction table. Use
PURGE AMP COR
to clear an existing amplitude-correction table.
Press
Edi-t;
Amp
Cor to edit an existing amplitude-correction table or, if no
amplitude-correction table currently exists, to create an amplitude-correction
table.
Pressing PURGE AMP COA two times consecutively clears an existing
amplitude-correction table.
Pressing SELECT POINT specifies the amplitude-correction point to be
entered or edited. Amplitude-correction data is constructed from left to
right and is created by entering frequency and amplitude values into an
amplitude-correction table. The frequency and amplitude values specify a
coordinate point from which amplitude-corrections are interpolated. See
Figure 3-13. Up to 79 points can be specified for the amplitude-corrections
table.
3-61