Filter
Top Products
I
-
Preparing For Use
Printing or Plotting
5.
To set the baud rate to 9600 baud, press: BAUD RATE , 9600, (Hz).
NOTE
The HP
7470A
plotter does not support two plots per page. If you use an HP
7470A
plotter with an
HP
8591C
cable TV analyzer, you can select one plot per page or four plots per page, but not two
plots per page.
6. Press
(j-1,
Plot Conf ig . You can choose a full-page, half-page,
or quarter-page plot with the
PLTWPC
I
2 4
softkey.
Press
PLTWPG
1 2 4 to underline the number of plots per page desired.
7. If two or four plots per page are chosen, a function is displayed that allows
you to select the location on the paper of the plotter output. If two plots
PLT
Cl
per page are selected, then the LDC
_
_
function is displayed. If four
PLT
Cl
_
plots per page are selected, then the LOC
_
_
is displayed. Press the
softkey until the rectangular marker is in the desired section of softkey
label. The upper and lower sections of the softkey label graphically
represent where the plotter output will be located.
l-23
-