Filter
Top Products
Model 9110TH NOx Analyzer Setup Menu
Teledyne Analytical Instruments 121
5.9.3.4. Automatic Group Calibration of the Analog Outputs
IMPORTANT
IMPACT ON READINGS OR DATA
Manual calibration should be used for any analog output set for a 0.1V
output range or in cases where the outputs must be closely matched to
the characteristics of the recording device. (See Sections 5.9.3.2, 5.9.3.3,
and 5.9.3.6).
IMPORTANT
IMPACT ON READINGS OR DATA
Before performing this procedure, ensure that the AUTO CAL for each
analog output is enabled. (See Section 5.9.3.3).
To calibrate the outputs as a group with the AOUTS CALIBRATION command, select the ANALOG
I/O CONFIGURATION submenu (see Figure 5-5) then press:
5.9.3.5. Automatic Individual Calibration of the Analog Outputs
To use the AUTO CAL feature to initiate an automatic calibration for an individual analog output, select
the ANALOG I/O CONFIGURATION submenu (see Figure 5-5) then press: