Filter
Top Products
If you want to delete an edge specification, place the cursor on the arrow
for that channel and touch the . (period). To clear an entire label, touch
CLEAR in the pop-up.
When you have finished specifying edges, touch Done to close the pop-up.
An example of a positive, negative, and either edge specification is shown
below.
Note When you close the pop-up after specifying edges, you will see ($$..)in
the Then find Edge field. These indicate edges have been specified;
however, the logic analyzer can’t display them correctly unless you have
selected Binary for the base.
Figure 5-44. Combination of Edges Specified
Menus HP 16510B
5-40 Front-Panel Reference