Filter
Top Products
3. Assign Pod 1 bits 0 through 15 to the label DATA.
a. Touch the bit assignment field below Pod E1 and to the right of
DATA. You will see the following pop-up.
Any combination of bits may already be assigned to this pod; however,
you will want all 16 bits assigned to the DATA label.
b. Using the knob, place the cursor on each un-assigned bit (one at a
time and touch the asterisk (*) field. When all 16 bits are
assigned, touch DONE to close the pop-up.
Figure 8-6. Bit Assignment Field
Figure 8-7. Pod E1 Bit Selection
Using the State Analyzer HP 16510B
8 - 8 Front-Panel Reference