Filter
Top Products
Disconnecting
the Probes
from the Pods
The probes are shipped already installed in the pods. However, you can
disconnect any un-used probes from any of the pods. This keeps the
un-used probes from getting in your way.
To disconnect a probe, insert the tip of a ball-point pen in the latch
opening and push while gently pulling the probe out of the pod connector
as shown below.
You connect the probes to the pods by inserting the double pin end of the
probe into the pod. The probes and pod connector body are both keyed
(beveled) so that they will fit together only one way.
Figure 2-8. Disconnecting Probes from Pods
Probing HP 16510B
2 - 10 Front-panel Reference