Filter
Top Products
Acquiring the
Data
Now that you have configured and connected the logic analyzer, you
acquire the data for your measurement by touching the Run field. The
display switches to the Timing Waveforms menu when the logic analyzer
starts acquiring data. The logic analyzer will look for a negative edge on
the RAS signal and trigger if it sees one.
If this is the first time you acquire data and you have not previously set up
the Timing Waveforms menu, you will see a label named "RAS" and a
label named "CAS all." The "CAS all" indicates all bits assigned to the
CAS label will be displayed. In this example, "CAS" and "CAS all" will
be the same since only one bit has been assigned to the CAS label. To turn
on just the "CAS" label and delete the "CAS all" label, follow these steps:
1. Touch the large blue field where the "CAS all" label resides.
2. When the pop-up appears, place the cursor on the "CAS all" label
and touch the Delete field.
3. Touch the "CAS" field and the "CAS" label will appear below the
"RAS" label.
4. Touch Done when you are finished.
Figure 7-6. Timing Waveforms Menu
Using the Timing Analyzer HP 16510B
7 - 8 Front-Panel Reference