Filter
Top Products
How to
Select Menus
Before you try to select one of the main menus, make sure the field in the
upper left-hand corner is set to State/Timing E. If the HP 16500A is in
System or Intermodule, touch that field and select State/Timing E when
the pop-up appears.
Note The field containing State/Timing (x) may have a different letter
following State/Timing. Don’t be alarmed. This letter merely tells you
what card slot the State/Timing module is in.
To select the main menus touch the second field from the left at the top of
the screen. A pop-up appears showing you the active menus. The menus
are:
• Configuration
• Format 1, 2, or both
• Trace1,2,orboth
• Waveform (Timing analyzer only)
• Listing (State analyzer only)
When the menu is displayed you can access the fields within the menus.
The second field from the left in the upper left-hand corner always
displays the current menu. To move around in the menu tree, you must
always touch the field displaying the current menu and select a new menu
when the pop-up appears.
The Configuration, Format, Trace, Waveform, and Listing menu fields
provide access to their respective menus. All menus, subsystems, and
fields in the entire logic analyzer are pop-ups that appear on top of the
currently displayed menu.
If more than one analyzer (machine) is on, you see the selected menu of
either analyzer 1 or analyzer 2 depending on what analyzer menu was
last displayed or what you did in the State/Timing E Configuration
menu.
To switch from one of these menus to another menu within the same
analyzer (machine) touch the current field (i.e. Waveform), which is
displayed in the field second from the left in the upper left corner and
make a new selection.
Using the Front-Panel Interface HP 16510B
3-2 Front-Panel Reference