Filter
Top Products
If you select this field you get a pop-up similar to that shown:
The pop-up lists all the symbols defined for that label. It also contains an
option absolute. Placing the blue bar on this option causes another field
within the pop-up to appear. This field is labeled offset______.Theoffset
field lets you specify a pattern not given by one of your symbols.
To select an option from the pop-up, use the KNOB to roll the symbols up
and down until the desired symbol is highlighted by the blue bar. Touch
Done to close the pop-up and place the symbol name in the Find Pattern
field under the label.
When you specify symbols in the Timing Symbol Tables,youalso
specify the number of characters in the symbol name that are to be
displayed. If you specify to display only three characters of a symbol
name, only REA of READ and WRI of WRITE would be displayed in the
Find Pattern field. In addition, only the first three letters of absolute
would be displayed.
Figure 5-39. Symbol Selection Pop-up for Find
Menus HP 16510B
5-36 Front-Panel Reference